Materials Testers
Characterize and analyze the behavior of materials, components, and assemblies by measuring tensile and compressive stress, strain, and associated materials testing calculations.
From metals to polymers, from wood to biomaterials, Mark-10’s IntelliMESUR® materials testers configured with the Materials Testing Calculations module can help engineers, researchers, and quality control professionals gain confidence in the performance of a variety of samples.
Common materials testing calculations include:
Stress
Stress equals force divided by the cross-sectional area of the sample,
commonly measured in psi or MPa.
Strain
Strain is the percentage deformation of a sample while under load,
measured from its original length between the grips.
Young’s Modulus
Young’s modulus, otherwise known as modulus of elasticity,
is the slope of the elastic portion of a stress-strain curve.
Yield Strength
Yield strength is the amount of stress that can be developed in a
material without causing plastic deformation; in other words,
the transition point from elastic to plastic behavior.
Offset Yield Strength
Offset yield strength approximates a stress just beyond the
elastic limit. Draw a parallel line to the Young’s Modulus,
offset by a specified amount, commonly 0.2%, and identify
the intersection point along the stress-strain curve.
Ultimate Strength
Ultimate strength refers to the maximum observed stress during the test.
Rupture
Rupture is the amount of stress at which the sample breaks.
A break can be defined as a specified percentage of drop
from the ultimate strength.
Mark-10 systems can additionally calculate the following:
- Percent elongation
- Flexural modulus
- Force per unit width
- A wide variety of results based on the above calculations, such as stress at maximum strain, strain at rupture, etc.
IntelliMESUR® Tensile and Compression Testing Systems
Model F505H
- Maximum load: 500 lbF [2.2 kN]
- Horizontal orientation
- 18.0 in [457 mm] of travel
- From $12,200